SEGWAY NINEBOT MAX G3 G3 TO GT3 BATTERY SWAP INSTRUCTIONS Tools needed: Place the scooter on its side and remove 11 screws to open the battery compartment using the segway 3mm hex tool Carefully remove 2 pieces of tape holding the wires to the battery and cut 2 zip ties holding the bundle of connecters wrapped in tape 2. Carefully remove the tape around the white cable coming from the battery 1. Unplug the main battery cable 3. Unplug it Unplug the cable shown below Optionally, remove the plug below it to make more cable clearance to remove the battery. Use a flathead screwdriver to help disconnect it. Remove the 2 screws holding the battery fixing platen using the segway 3mm hex Remove the battery On the new GT3 battery, use a hair dryer or heat gun on low setting to remove the 2 side pieces of foam Use caution while heating up the foam pieces on the battery. Do not heat the battery too much. Using a hair dryer or heat gun, remove and transfer foam pieces from G3 to GT3 battery. This will ensure the battery is fixed in place and prevent rattling. GT3 Battery G3 Battery G3 Battery Use caution while heating up the foam pieces on the battery. Do not heat the battery too much. Remove the long and thin piece of foam and replace it with the short and thick piece of foam G3 Battery GT3 Battery 1. Slide the battery back in with the barcode facing you 2. Plug everything back in 3. Turn the scooter on to ensure everything is working properly 4. Screw the battery fixing plate back in place 5. Wrap the tape back around the white wire 6. Zip tie the cables back together 7. Place the 2 large pieces of tape back holding the wires, ensuring they are running down the middle Place the cover back on and reinstall 11 screws