Batumi (Individual Wavebank Firmware) Xaoc Devices C ONTROLS 1. SLIDER 2. FRQ•PH•DIV 3. RESET|SYNC 4. SINE 5. SAW|ASGN 6. SQUARE 7. LFO Sync Mode Z OOM M ODE P ress Mode button for 1 second...LED blinks for the last slider that was moved. Exit ZOOM mode by tapping Mode button. LEDs will flash quickly if the value of a parameter does not correspond to the position of its slider • Slider 1: Fine tunes the value of the main parameter (frequency, level, phase or division) In DIVIDE mode, will add / subtract 0 - 3 to the division set outside of ZOOM mode. • Slider 2: sets output levels of SINE and SAW /ASGN outputs...except i n QUAD where sets the division instead (from 1 to 8) • Slider 3: sets the CV attenuation • Slider 4 sets the phase...except in PHASE mode where sets the division instead (from 1 to 8) W AVEBANK S ELECT M ODE Press Mode button for 2 seconds...LEDs blink to indicate waveform of the current slider position. Move corresponding slider to select waveform fo r that channel from a value of 0 (slider down) to 4 (slider up). Exit ZOOM mode by tapping Mode button. • 0: Default (Saw, Ramp, Triangle or Trapezoid per jumper or Poti) • 1: Stepped Random • 2: Smooth Random • 3: Stepped Logistic (Verhulst’s) • 4: Smooth Logistic (Verhulst’s) R ESET M ODE Press LFO Sync Mode button for 4 seconds to reset all settings in Zoom mode and Wavebank Select Mode. Free New Quad Phase Divide Slider Frequency... 0.01Hz - 100Hz Amplitude Phase "Old" Quad at max Division... By 2,3,4,8,16,32 FRQ-PH-DIV RESET|SYNC - Ch 1 RESET|SYNC - Ch 2 RESET|SYNC - Ch 3 RESET|SYNC - Ch 4 SINE SAW|ASGN SQUARE ZOOM - Ch 1 Fine tune Frequency Fine tune Amplitude Fine Tune Phase Fine Tune Division ZOOM - Ch 2 Output Level Division Output Level Output Level ZOOM - Ch 3 CV Attenuation CV Attenuation CV Attenuation CV Attenuation ZOOM - Ch 4 Phase Phase Division Phase Reset LFO to 0 (RESET mode) or Tap Tempo (SYNC mode) Holds all channels while gate is high MODE CV added to Slider (CV + Slider <= +5V) Reverses direction of the waveform on trigger Cycle through waveforms on trigger Sine (-5v to +5v) Wavebank (-5v to +5v) Square (-5v to +5v) Nothing