PDF Host

Mazda2_zamok.pdf -

Please enable JavaScript to view the full PDF

14. 3. 2022 G297211.html REMOVAL AND INSTALLATION 2003.50 Mazda2 FRONT DOOR LATCH UID=G297211 Removal 1. Remove the front door trim panel. For additional information, refer to Section 501-05. 2. Remove the grommets. 3. Lower the front door window glass, until the door window glass retaining bolts are visible through both holes. 4. Loosen the front door window glass retaining bolts. 5. CAUTION: Make sure the front door window glass is adequately supported at the top of the window opening. Raise the front door window glass by hand and secure using a suitable wedge or tape. 6. Disconnect the exterior mirror and front door window regulator motor electrical connectors and detach the wiring harness (if equipped) from the door inner panel . 7. Disconnect the front door latch electrical connectors and detach the wiring harness (if equipped) from the front door inner panel. 8. Detach the front door speaker and wiring harness. 1 14. 3. 2022 G297211.html 9. Remove the front door latch access panel. 10. Remove the grommet. 11. Remove the door lock security shield retaining bolt. 12. Disconnect the exterior front door handle actuator rod. 13. Disconnect the door lock security shield retaining clip and remove the door lock security shield. 2 14. 3. 2022 G297211.html 14. Disconnect the front door lock cylinder rod. 15. Remove the front door latch retaining screws. 16. Remove the front door inner panel retaining bolts. 17. Remove the front door inner panel. 1. Pull the front door inner panel out at the bottom. 2. Lower the front door inner panel on the right-hand side and then slide it towards the front of the car. 18. Remove the front door latch retaining screw from the door inner panel. 3 14. 3. 2022 G297211.html 19. Detach the front door latch cables from the door inner panel. 20. Detach the interior door handle from the door inner panel. 21. Disconnect the front door latch cables from the interior door handle and remove the front door latch from the door inner panel. Installation 1. To install, reverse the removal procedure. 4