SUSAN’S C R A F T PA R T Y Boho decorative planter SIDES | CUT 2 FOAM CORE BOARD PATTERN AND INSTRUCTIONS PAGE 1 OF 4 All of my projects are made with items I have. Feel free to sub out materials for what you have. Project ideas are for inspiration. SUSAN’S C R A F T PA R T Y Boho decorative planter MATERIALS FOAM CORE BOARD I get mine at DT SMOOTH SURFACE DISPOSABLE COOKING SHEET I got mine on Amazon WOODEN HALF-BEADS 26 12mm and 26 18mm WOODEN BEADS 4 20mm round SPACKLE CHALK PAINT White WAVERLY ANTIQUE WAX (optional) BABY WIPES (optional) HOT GLUE GUN HOT GLUE SCISSORS SUSAN’S FAUX STUCCO MIX 1 Cup chalk paint (I used white) 1 Tablespoon Mod Podge 4 Tablespoons white sand (Hobby Lobby and DT have sand) I keep mine in a sealed container and it lasts for several projects. INSTRUCTIONS STEP 1 Cut 2 pattern pieces out of foam core board. STEP 2 Cut 2 5” strips of cookie sheet. Take a ruler and mark 1/2 inch down both long sides. Careful edges are sharp. 5'' 1/2'' NOTE ABOUT THE PLANTER Designed for decoration, not designed to put dirt directly into. I have a small plastic flower pot with a saucer in mine. PAGE 2 OF 4 STEP 3 • Starting at the top edge of foam board half circle, hot glue the first strip of cooking sheet following the curve. Wrap until it runs out. Overlap the second strip by 1/2 inch and continue to opposite end. • Glue second half circle of foam board to opposite side. • After both half circles are glued to the cooking sheet strip, trim extra strip to top of half circles. Trim excess to top edge of half circles. Overlap STEP 4 Make 1/2 inch cuts to the edge of the half circle. All the way around on both sides. PAGE 3 OF 4 STEP 5 Fold down and glue cut edges. When you’re done it should look like this on both sides. STEP 6 Lightly spackle entire project paying close attention to edges and the connecting seam. Let dry completely. Lightly sand smooth. It’s ok if it looks rough, it adds texture. STEP 7 Glue on both sizes of half beads with hot glue. I put beads on both sides. STEP 8 Glue on 20mm bead feet. I spackled the holes and let dry before gluing them on. STEP 9 Cover the entire project with Susan’s Faux Stucco Mix. Let dry. STEP 10 Leave plain or add a rustic look by lightly rubbing on a stain. I used Waverly Antique wax with a baby wipe. PAGE 4 OF 4