Quick Solutions to Common Issues: INSTALLATION INSTRUCTIONS 🔧 Missing parts? We've got you covered! 📦 We'll ship replacements asap! Email with: Your order #: Shipping address: Best phone number: Flip hinges 180° before installing 2 If you have any questions, please do not hesitate to contact us. If the stoppers won't fit into the toilet seat mounting holes from the top: A: Gently loosen the screws on both ends of the hinge counterclockwise with the supplied 2.5mm hex wrench. （ Do not fully tighten ） Q: Quick-Release Function Not Smooth A: Clean surfaces with mild soap solution. Avoid alcohol/chlorine/acid-based cleaners While our toilet seat hinges are built to stay tight, daily use or installation quirks might occasionally loosen them. Just use the nut key to tighten the fittings in the loose locations following the installation steps if needed. 🔧 TIPS: Cleaning Instructions 🔧 Pro Tip: Keep your Allen wrench & Nut key – you’ll need them! ④ Removing the Seat: Lift the seat, gently wiggle it side-to-side to loosen, then pull straight up. Reattaching: Line up the hinges with the mounting discs and push down firmly until you hear a click. Quick-Release Hinge Operation Guide Flip the approach - install from underneath instead Install in the order shown in the figure Not turning 180° causes the toilet seat too short 1 1 2 2 1 2 🔍 Seat looks short? Don't panic! ⑧ ④ ① ③ ⑤ ⑥ ⑦ ② ⑨ Installation Accessories YouTube Install Video QR Code YouTube Channel: Angol Shiold / Angel Shield E-mail: inquiry@angelshield.cn Please be patient and believe we will try our best to the products problems. STEP 1: Rotate the hinges 180, and straighten hard. Not turning 180° causes the toilet seat too short ① Screw ② Hinge disc ③ Anti-slip gasket ④ Stopper ⑤ Gasket ⑥ Nut ⑦ Nut key ⑧ Rubber anti- skid pad ⑨ Hinge- cover ⑩ Mini hex wrench X2 X2 X2 X2 X2 X2 X1 X2 X2 X1 STEP 2: Put the pads into the hinges. (Prevent sliding) STEP 3: Put the stoppers into the toilet holes STEP 5: Adjust the toilet seat to be compatible with the toilet. STEP 6: Install bottom screws as shown. STEP 7: TIPS: Close the hinged covers. If the hinge is too loose or too tight, use the mini hex wrench to adjust the small holes on both sides of the hinge. （ Do not fully tighten ） STEP 4: Install accessories as shown