The safer , easier way to help you pass any IT exams. 1 / 9 Huawei H35-580_V2.0-ENU Exam HCIA-5G-RNP&RNO V2.0 https://www.passquestion.com/h35-580_v2-0-enu.html 35% OFF on All, Including H35-580_V2.0-ENU Questions and Answers Pass Huawei H35-580_V2.0-ENU Exam with PassQuestion H35-580_V2.0-ENU questions and answers in the first attempt. https://www.passquestion.com/ The safer , easier way to help you pass any IT exams. 2 / 9 1. In the continuous CA scenario in the protocol frequency band, what is the maximum center frequency band interval between carrier 1 (60MHz bandwidth) and carrier 2 (100MHz bandwidth) in the n41 frequency band? A. 89.8MHz B. 99.8MHz C. 69.8MHz D. 79.8MHz Answer: D 2. Which of the following manufacturers was the first to complete the SA functional test of the domestic IMT-2020 5G Promotion Group? A. Huawei B. Ericsson C. ZTE D. Nokia Answer: A 3.Which piece of information will not be referenced by the automatic deletion of neighbor relations feature? A. Neighborhood specifications B. Neighborhoods that have not been used for a while C. gNodeB Neighborhood Cell Specifications D. X2/XN Specifications Answer: D 4. The redirection process has lower service interruption delay than the switching process. A. True B. False Answer: B 5. The scheduling priority of retransmitted data is higher than that of initially transmitted data. A. True B. False Answer: A 6. Which of the following in the terminal capability report indicates that the terminal supports antennas ? A. SupportedsRs-Resourse B. maxNumberSRS C. SupportedSRS-AntennaSwitching D. SupportedSRS-TxPortSwith Answer: C 7. The terminal can send a power control command to the base station to control the transmit power of the PDSCH. The safer , easier way to help you pass any IT exams. 3 / 9 A. True B. False Answer: B 8. Imbalanced terminal receiving antennas will affect RANK performance. Generally, within what range can the average RSRP difference of different antennas be considered balanced? A. 6dB B. 8dB C. 4dB D. 2dB Answer: A 9. The initial TA (time advance) adjustment of the terminal is obtained through which of the following messages? A. SIB1 B. Random access response C. RRC connection setup D. RRC Reconfiguration Answer: B 10. The distribution link of the smart grid will use both wireless and wired networks. A. True B. False Answer: A 11. As long as the SSB frequency or SCS between the serving cell and the neighboring cell is different, the terminal's measurement of the neighboring cell is an inter-frequency measurement. A. True B. False Answer: A 12. For SA networking, voice solutions include VONR and CSFB A. True B. False Answer: B 13. For the N78 frequency band, which of the following time slot ratios (downlink, uplink) can support the transmission of SSB beams? A 4:01:00 B. 3:01:00 C. 7:03:00 D. 8:02:00 Answer: C The safer , easier way to help you pass any IT exams. 4 / 9 14. For a 60KHZ SCS configuration, how many time slots are included in a radio frame? A. 40 B. 80 C. 160 D. 20 Answer: A 15.For a 100MHz cell, when the downlink uses type 0 allocation, what is the minimum resource allocated in the frequency domain? A 16RB B. 4RB C. SRB D. 2RB Answer: A 16.How much data does the SSB that occupies 20 RB resources carry? A. 432 bits B. 576 bits C. 972 bits D. 864 bits Answer: D 17.Which parameter indicator will not be referenced in the SCell deactivation management of carrier aggregation? A. Data volume in UE downlink RLC buffer B. Spectral efficiency corresponding to SCell CQI C. Spectral efficiency corresponding to SCell SRS D. UE_BSR data volume scheduled uplink Answer: C 18. When testing the downlink peak value of an NR network, which of the following should the PDSCH DMRS type be configured to? A. Type3 B. Type2 C. Type1 D. Type4 Answer: B 19. If the MeasAndMobParametersMRDC of the terminal MR-DC capability contains the independentGapConfig information element, which GAP configuration is recommended for NR inter-frequency measurement? A. Per gNodeB GAP B. Per FR1GAP C. Per eNodeB GAP The safer , easier way to help you pass any IT exams. 5 / 9 D. Per UE GAP Answer: D 20. In the existing network, we recommend that all cells use the configuration parameters under the peak rate scenario to improve user experience A. True B. False Answer: B 21. During downlink data transmission, if the terminal suddenly fails to report CQI, what will happen? A. Downlink data transmission stops B. Dropped calls C. Use the currently used MCS for data transmission D. Use a fixed low-order MCS Answer: D 22. In downlink detection, what is the PDCCH BLER synchronization threshold Qin? A. 0.1 B. 0.02 C. 0.15 D. 0.05 Answer: A 23.Which of the following factors is not involved in calculating the number of RBs for a user in downlink scheduling? A. RI reporting B. MCS C. PMI reporting D. Cache data volume Answer: C 24. During downlink scheduling, which of the following services has the highest scheduling priority? A. RRC signaling B. SIB C. MIB D. VoNR service Answer: C 25. During the downlink MCS adjustment process, the base station makes the adjustment based on which of the following measurements? A. PDSC H SINR B. PDCC H SINR C. PDSC H BLER D. PDCCHBLER The safer , easier way to help you pass any IT exams. 6 / 9 Answer: C 26. During the same-frequency cell reselection process, if you want to make it easier for the terminal to reselect from the serving cell to a specific neighboring cell, how can you modify the parameters ? A. Increase Qoffset B. Increase Qhyst C. Reduce Qoffset D. Reduce Qhyst Answer: C 27. Among the A3 event parameters for intra-frequency handover, which of the following parameters cannot be configured individually based on QCI? A. A3 bias B. Neighborhood Offset (CIO) C. A3 Amplitude Hysteresis D. A3 time lag Answer: B 28. When using Probe to test the NSA network , it is found that the MAC layer rate of LTE uplink is 20Mbps, but the PDCP layer rate is 0. Which of the following understandings is correct? A. The bit error rate is too high and the data is retransmitted. B. LTE data converges to NR's PDCP layer C. Tool statistics anomaly D. PDCP layer failure Answer: B 29. In the uplink power control process, the power control of SRS is related to the power control of which channel? A. PRACH B. PUSCH C. DMRS D. PUCCH Answer: B 30. During uplink scheduling, what is the fixed value of the “ logical channel guaranteed rate ” for each non-GBR logical channel? A. 16kbps B. 32kbps C. 8kbps D. 4kbps Answer: C 31. During the handover preparation process, the source cell determines the target cell for handover based on which of the following parameters? The safer , easier way to help you pass any IT exams. 7 / 9 A. PCI B. NCGI C. TAC D. Frequency Answer: A 32.Which of the following parameters does not need to be configured in the command to configure the 5G external cell? A. PCI B. gNode B ID length D. TAC D. gNode B ID Answer: B 33. In each TTI scheduling, the scheduling priority of the control plane information is absolutely higher than the scheduling of the data plane. A. True B. False Answer: A 34. In the drive test tool, which of the following indicators cannot be monitored? A. SSBRSRP B. PDSCHIBLER C. CQI D. SRSSINR Answer: B 35. In the process of connecting A from in-vehicle information services to intelligent transportation, the intelligentization of the network and the intelligentization of the infrastructure need to work together. A. True B. False Answer: A 36. In an inter-frequency handover scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurements? A. A2 B. A4 C. A3 D. A1 Answer: D 37. In high frequency scenarios, what is the maximum subcarrier spacing that can be used for all channels and signals? A. 240KHZ The safer , easier way to help you pass any IT exams. 8 / 9 B. 120KHZ C. 30KHZ D. 60KHZ Answer: A 38. In low-frequency scenarios, how does the UE obtain the beam ID of the current SSB? A. Obtained through MIB messages B. Obtained through PBCH DMRS C. Obtained through PBCH physical layer coding information D. Obtained through SIB1 message Answer: B 39. In the window size, the larger the window, the stronger the resistance to delay A. True B. False Answer: A 40. In the UE access anchor point policy, if the "cell prohibited" state is set to "prohibited", the UE cannot occupy the resources of this cell. A. True B. False Answer: A 41. In the SIB1 message, if the expected preamble power is -100dBm, the SS B transmit power is 18dBm, and the current RSRP is -90dBm, what is the preamble transmit power of the first PRACH of the terminal? A. 10dBm B. -108Bm C. 8dBm D. -118dBm Answer: C 42. When downloading in SA networking, which event initiates the handover decision phase due to poor signal in the serving cell? A. A1 B. A2 C. A3 D. A4 Answer: B 43. In SA networking, the mobility between adjacent cells on the same frequency can use the redirection process. A. True B. False Answer: B The safer , easier way to help you pass any IT exams. 9 / 9 44. In RAN3.0 version, for TDD 5G network, only case C SSB beam pattern is supported. A. True B. False Answer: A 45. In RAN3.0, for the mobility algorithm of SA network, how many A2 thresholds can be set on the base station side? A. 4 B. 3 C. 1 D. 2 Answer: D 46. In RAN3.0 version, which of the following PUCCH formats does the base station not support? A. Format1 B. Format2 C. Format4 D. Format3 Answer: C 47. In RAN3.0 version, CSI-RS for beam management is not supported in low-frequency scenarios A. True B. False Answer: A 48. In RAN 3.0, what is the minimum configuration of PDCCH bandwidth in a cell-specific BWP? A. 6RB B. 24RB C. 48RB D. 12RB Answer: A 49. In the downlink channel configuration in RAM 3.0 version, what is the maximum power offset? A. 15dB B. 9dB C. 6dB D. 12dB Answer: A