Rajiv Gandhi University of Knowledge Technologies Department of Mechanical Engineering Engineering Graphics and Computer Drafting (20ME1214) Assignment - 0 4 1. Draw the projection of a 75 mm long straight line, which is parallel to both H.P. and V.P. and 25 mm from each. 2. Draw the projection of 50 mm long straight line, which is perpendicular to H.P and 20 mm in front of V.P. and its one end 15 mm above the H.P. 3. The length of top view of a line parallel to V.P. and inclined at 45 degrees to the H.P. is 50mm. One end of the line is 12 mm above the H.P. and 25 mm in front of the V.P. Draw the projections of the line and determine its true length. 4. A 90 mm long line is parallel to and 25 mm in front of the V.P. Its one end is in the H.P. while the other is 50 mm above the H.P. Draw its projections and find its inclination with H.P. 5. A 100 mm long line is parallel to and 40 mm above the H.P. Its two ends are 25 mm and 50 mm in front of the V.P. respectively. Draw the projection and find its inclination with the V.P. 6. A line parallel to both the H.P. and V.P. has its front view length of 50 mm. It is 20 mm above H.P. and 50 mm in front of V.P. Draw it projection and determine its actual length. 7. A line CD is 30 mm long is parallel to V.P. and perpendicular to H.P. Point C is 20 mm above H.P and 30 mm in front of V.P. Draw the projections. 8. Top view length of a line AB which is perpendicular to V.P. is 60 mm. Its end A is 30 mm in front of V.P and 20 mm above H.P. 9. A line PQ 40 mm long is parallel to V.P. and inclined at an angle of 30 degree to H.P. The end P is 20 mm above H.P and 20 mm in front of V.P. Draw the projections of line. 10. A line of AB of 50 mm long, one of its end A is in H.P. and 20 mm in front of V.P. It is inclined at an angle of 30 degrees to H.P. and parallel to V.P. Then draw its projections. Note: This sheet to be submitted before: